Here is the link to the manual.click around to get other info on the board. Not sure, but I think your CPU jumpers may be off for a real K6-2/266 (2.2/3.3V, 66MHzx4).make sure you really have one, unless you are overclocking, etc. But check the basics first, and make sure you are set up correctly for your hardware. If the battery is good (CR2032) and it is installed correctly (you can read the numbers on it), maybe the trace to the CMOS chip is open. also IrDAĭownload the manual and check your jumpers. J14 - Header for all your buttons out front, speaker, etc. J15 - CPU Cooling Fan, if you have one connected there JP7/6 - CPU Voltage and t acording to your CPU J13 - is for USB cable to outside world.no jumpers JP9 - mine has caps, but they are all open (CPU MHz) Later u can get back to the CMOS settings again to fine tune it. Choose 'Load Defaults for optimal performance' OR 'for fail-safe'. When the computer starts goto to CMOS (BIOS setup) setup. My full ID string is 07/08/98-ALi-154x-2A5KIB09C-00. U might have to clear CMOS and enable it again in one of the jumpers (refer to your motherboard manual usu. and I got this BIOS file from the BIOSTAR site. Interesting.mine says ATC0708B and not D. so it wont retain any new programing or programs installed.ĢA5KI ALI IV+ M1531/M1543 Chipset (also known as Super TX chipset)ĭevice=ALi M1531 Aladdin IV 586-Chipset, Rev=B3hĭevice=ALi M1543 Function 0: PCI to ISA Bridge, Rev=B4hĠ3 0 Vendor=1317h - new vendor ID No PCI-INTĭevice=ALi M1543 PCI Enhanced IDE Controller, Sub-Device, Rev=20h NOW you have to turn it off cold to get it to shut down. ive prayed really very hard to the Mother board fairy.īut my computer will not keep time, and it always says at startup ive tried reconfiguering the CMOS settings, ive reformated. Help! i have replaced the coin battery have taken it out and tested the battery to make sure it is charged.
0 Comments
Leave a Reply. |